Instructions Hot Tub Comfort

This is how it works step by step:

 1. cover the hot tub and open the pump shaft in the step area.

2. make sure that the blue drain valve is at right angles to the pipe.

3. push the slide valve down to close the drain.

4. open the water pipe in the direction of the pipe in the inlet area. Observe the screw valve (green or red).

5. Wait 1-1.5 hours for water to reach the mark.

6. close the valve again.

7. insert all plugs in the pump shaft.

8. set the desired temperature.

9. press the button on the housing to start the pump.

10. on departure: Pull out the plug & open the cables.

Done - have fun relaxing!

Here's how it works - step by step.

1. uncover your hot tub & open the pump compartment near the steps.

2. turn the blue valve perpendicular to the vertical pipe to close the drain.

3. check the fuse box in the pump area - all fuses must be ON.

4. open the cabinet in the entrance area.

5. turn the screw valve (green or red) vertically to start the water flow.

6. wait 1-1.5 hours until the water reaches the marker.

7. close the valve again.

8. set your desired temperature using the controller in the pump compartment.

9. before departure: open the drain to empty the tub.

Welcome to your little luxury!